Burg Super descaling cartridge for Burg Duracraft Honeywell ultrasonic humidifiers BH-860E / BH-861E / BH-862E BH-870E / BH-871EShipping costs for 1 item: from Fr. 10.- (Basic B-Post, further shipping options can be found in "My Cart").Quantity discount heading "Humidifier Spare Parts" (including mixed items):5% discount on 2 items, 10% discount on 3 or more items Technical dataLifespan of the descaling cartridge at 0 - 10° dH approximately 5 monthsLifespan of the descaling cartridge at 10 - 15° dH approximately 3 months

Learn more More Fewer

Combined EPA - Activated Carbon Filter Combination (E11) suitable for Air Purifier WDH-H600A. The replacement is easy and occurs when the already installed filter can no longer fulfill its function.ParticleThe EPA is a high-performance particulate filter (EPA = Efficient Particulate Air filter) with a purity rate of 95%. It captures particles up to 0.001 mm in size. This filter can be used in addition to the HEPA and activated carbon filters in the device to enhance the result with each pass of air through the device, or it can also be used as a standalone filter against odors and particles. Its purity rate is slightly lower than that of the HEPA filter (0.0003 mm). It provides supportive virus protection, but is not equally protective as the HEPA H13.odors/fumesAbsorbs and cleans many types of smoke and odors (e.g. cigarette smoke) and also helps to break down toxic vapors, gases, and solvents (e.g. formaldehyde, benzene, ammonia, sulfur, etc.).This combination filter is ideally placed in the lowest filter compartment of the device, that is, after the coarse dust filter (pre-filter) but before the fan. In this way, it protects the motor from contamination and reduces the amount of particles that would otherwise only be filtered out by the subsequent HEPA H13 filter. Since the HEPA H13 filter is more expensive than the pre-filter, this combination makes sense and extends the maintenance interval, that is, the time until the next filter change is due.Minimum order quantity 1 piece.

Learn more More Fewer

The tub is made of black ABS plastic, the safety bracket is made of stainless steel 1.4301 (acid-resistant, non-corrosive 18/10 chrome-nickel steel), electropolished. Also available as a complete set with wall protection plate.

Learn more More Fewer

The tub is made of silver ABS plastic, the safety bracket is made of stainless steel 1.4301 (acid-resistant, non-corrosive 18/10 chrome-nickel steel), electropolished. Also available as a complete set with wall protection plate. 

Learn more More Fewer

Replacement filter cartridge for humidifier Sonnenkönig Hygro800 Contains a humidification filter suitable for the Hygro800 humidifier.Depending on water hardness, the filter should be changed approximately every 2 to 3 months.Humidifier models:Sun King Hygro 800Shipping costs for 1-2 items: from Fr. 10.- (Basic courier, further shipping options can be found in "My Cart"). Technical dataHeight: 245 mm Width: 420 mm Depth: 120 mm Sun King Article Number: 10480

Learn more More Fewer

Filter set of 2 filters (1 x HEPA, 1 x activated carbon) for air purifier WDH-220b consumablesTechnical data1 x HEPA-Filter1 x activated carbon filter

Learn more More Fewer

Replacement filter block for air purifier WDH-80AShipping costs for 1 item: Fr. 10.- (Based on B-Post, further shipping options can be viewed in the shopping cart) Technical dataWeight: 4kg

Learn more More Fewer

Filter set of 3 filters (1 x HEPA, 1 x activated carbon, 1 x catalyst) for air purifier AP1101consumablesEnrichment:5% on 2 complete filter packages10% off 3 complete filter packagesShipping costs for 1 set: Fr. 10.- (Basic B-Post, further shipping options can be viewed in the shopping cart) Technical data1 x HEPA-Filter1 x activated carbon filter1 x Catalytic converter filterDimensions: Length 35 cm, Width 27 cm, Height 1-2 cm

Learn more More Fewer

Replacement filter set of 3 filters (1 x HEPA, 1 x activated carbon, 1 x catalyst) for air purifier C03.consumables.

Learn more More Fewer

The "B2-PTC" is a very effective heater for rooms, cars, and caravans.The ceramic heating element provides an incredibly good efficiency of input energy to generated heat. It is therefore ideal wherever only standard household sockets are available, but maximum heating power is required.It is also noticeable that the heating phase is much faster, as the heater reaches operating temperature within a few seconds. It heats the air by a whopping 65°C (difference between intake air temperature and exhaust air temperature), which is almost double the difference compared to conventional construction heaters. Therefore, this heater should not be placed within reach of children.The heating power can be selected in two stages: 1000W or 2000W. The target temperature is determined via a stepless thermostat controller.Normal current 230/V, min. 10 Amperes, Swiss plug with connection cable.Product advantages• Room thermostat included• No oxygen consumption• Odorless, no exhaust gases, no condensate water• Quiet running• Motor with thermal protection• Overheating thermostat• Built-in thermostat• Automatic Reset   Technical data  Dimensions (W x H x D)  200x200x200 mm Weight 2.5 kg Housing color Metal yellow powder-coated Protection class IP21 Selectable heating power 1000 / 2000W insurance 8.7 A Motorspannung 230 V Motorstrom 0.2 A airflow 97 m³ / h temperature range 0 - 40 °C guarantee 2 years

Learn more More Fewer

Practical chassis, suitable for the dryers of these Krüger Secomat dryers:Secomat 100 (Art. 387.01/without heating)Secomat 100H (Art. 387.04/with heating) Secomat 150 (Art. 388.01/without heating) Secomat 150H (Art. 388.04/with heating) Secomat 200 (Art. 389.01/without heating) Secomat 200H (Art. 389.04/with heating)   The rolling frame is made of sturdy metal and features 4 wheels, 2 of which have brakes. It is ideal for situations where the dryer cannot be mounted directly to the wall, or when the device is used in different rooms. At the bottom, there is a metal plate on which the bucket for the condensate can be placed. All the necessary mounting materials for the Secomat are included in the delivery of the dryer.Technical data Material: metal, stainless Weight: 14.4. kg Masse H x B x T: 1267 x 620 x 800mm

Learn more More Fewer

Practical chassis, suitable for the tumble dryers     Krüger Secomat 2 (Art. 396.01 / 396.03) Krüger Secomat 4 (Art. 397.01 + 397.03)Krüger Secomat 75 (Art. 386.01)Krüger Secomat 75H (Art. 386.04)   The rolling frame is made of sturdy metal and features 4 wheels, 2 of which have brakes. It is ideal for situations where the dryer cannot be mounted directly to the wall, or when the device is used in different rooms. At the bottom, there is a metal plate on which the bucket for the condensate can be placed. All the necessary mounting materials for the Secomat are included in the delivery of the dryer.     Technical data Material: metal, stainless Weight: 13.4. kg Masse H x B x T: 1267 x 520 x 740mm

Learn more More Fewer